Buckle scaffold manufacturers on the product set up details

At present, the clap-type scaffold is the most advanced modular scaffold system, with high safety performance, labor saving, convenient installation and disassembly, consumption saving, overall beautiful. It is an ideal upgrade product after fastener type and bowl buckle type scaffold. There are many scaffolding manufacturers with different prices, but the actual operation details of the product are as follows.

Image upload

Coil buckle scaffold manufacturer product foundation testing:

1. Foundation requirements of frame body

Key points of inspection:

The pole foundation shall be smooth and tamped according to the requirements of the scheme, and drainage measures shall be taken to prevent water immersion, and the backing plate and base set at the bottom of the pole shall meet the requirements of the code. Clasp scaffold manufacturers will carry out product quality inspection before leaving the factory.

2. Set the bottom of the frame body

Key points of inspection:

The bottom of the vertical rod of the frame body should be provided with a backing plate and an adjustable base, and meet the specification requirements; The vertical and transverse sweeping rod of the frame body should meet the specification requirements.

Note: The height of the adjusting nut of the adjustable base should not be greater than 300mm, and the height of the horizontal rod of the sweeping rod should be less than 550mm.

Image upload

3. Even the wall

Key points of inspection:

The hook of the frame body and the building structure of the coil scaffold manufacturer should meet the requirements of the code, and the wall connecting parts should be set from the first step of the horizontal rod at the bottom of the frame body. When the setting is difficult, other reliable measures should be taken to fix it. The pull joint of the frame body should be firm and reliable, and the wall should be rigid rod.

Note: The wall connecting parts must be rigid rod parts that can bear tensile and compressive load. The wall connecting parts should be perpendicular to the facade and wall of the scaffold, and the wall connecting rods on the same floor should be in the same plane, and the horizontal spacing should not be more than 3 spans. The connection point with the frame body to the buckle node distance shall not be greater than 300mm; When the lower part of the scaffold cannot be erected for the time being, it is advisable to set up multiple rows of scaffolding and set up oblique rods to form an additional trapezoidal frame in the shape of the lateral inclined plane.

Key points of inclined bar inspection:

The vertical inclined bar of the frame body shall meet the specification requirements.

Rod fastener joint

Inspection requirements: the two ends of the vertical inclined rod are fixed at the buckle node where the vertical and transverse horizontal rods and vertical rods converge.

The bolt connecting the horizontal rod joint and the buckle plate should be hammered to a certain pulling force.

The foundation and foundation of the product column of the coil scaffold manufacturer must be solid, should have enough bearing capacity, and prevent uneven settlement or excessive settlement.